nytefog

Is anyone familer with old army trailer model M101A? It has a lunette ring on the trailer and i wanted to know what i need to couple it to my 07 limited V8? What is the best pintle coupler i can buy? I'm trying to buy this trailer through a liquidation site but don't know the height of the rind off the ground?

I've been looking at the Pintle with the ball and with out. I don't know what i should get...

I am a rookie at towing so i'm over whelmed with information! Please help!!

Attached picture of trailer.

Attached Images

 

__________________
2007 Limited V8, AWD, V1 & Remote Display, Pelican Storage Cases, Daystar 2.5/1.5 (3/13/11), 265/65/18 BFG TKO (12/28/11) , Die Hard PM-1, Schumacher SE-1-12S, Full Synthetic lube. (In-Search-of: USED Gobi Stealth roof rack)

Acidmeld

Since you don't know the height you can get a height adjustable pintle mount. http://www.hitchesonline.com/images/43049.jpg

If you tow a trailer with a standard ball mount regularly and don't want to swap hitches out all the time I'd go with a combo ball/pintle hitch.

__________________
2007 SportEdition V6 4WD Galactic Gray
Found on the trails of the Colorado front range
Daystar 2.5/1.5, Rear Diff Breather Mod, TRD Brake Pads, Full Synthetic 90w-135 Gear Lube, 265/70/17 Duratracs, Cobra 75, 3' Firestik,
Toyota Expert Tech/Lexus Certified Tech/ASE Master Tech

Pikeman

I have the same trailer and the pintle height is about 24-25 inches. Take a look at my thread below ... My slow expedition/ base camp build. If your truck is stock height you will need a height adjustable hitch mine pulled almost level with a 3" lift and 33" tires custom bumper mount. The factory reciever hitch is another 6" lower than what I have now.

__________________
1998 T4R SR5
All-Pro CO's, UCA's and Sliders, SS 1.2 rear only DIY rear bumper, Aussie Locker and 1st gen roll bar mod. Outdoor Logic Front bumper, roof rack and Vision X lights.
Future Mods: Winch, Skids, Lower Link Arms.
www.outdoorlogic.net