Quote:
Originally Posted by 4rociousrunner
So, I’m installing a lift kit on my 03 SR5...managed to remove tie rods, ball joints and LCA to isolate the strut. As I was removing the three top plate nuts, one of them seemed extremely stubborn. I used the ratchet hammer method, heated it, used wd40, heck I even tried splitting the nut. Nothing has worked over the course of TWO HOURS and IT WONT BUDGE....I need help ASAP....should I take a drill to it or a Dremel? Won’t be reusing the bolt or nut.
|
Cut it off is what I did. There is a write up link in my signature.
Sent from my Pixel 3 using Tapatalk