Took some better measurements this morning:

22” maybe a little less drivers side.

21.5” passenger

Truck always has some lean to it. Hoping it will settle out a bit.


The drivers side strut came apart yesterday because I’m missing the bottom washer in the bushing sandwich. It occurred to me last night that that’s why it did that. That was my mistake on the initial install. Doesn’t seem to affect much, but I still took the time, and searched for the washer with no luck. I’ll want to address that ASAP just to be sure (screams internally).

Anyways i suppose that’s it for this thread unless I hear what the issue was from Dobinsons.


Lessons here:

Take pre and post fender to hub measurements.

Beer is good.