Junior Member
|
|
Join Date: Nov 2018
Location: Huntsville, AL
Posts: 15
|
|
Junior Member
Join Date: Nov 2018
Location: Huntsville, AL
Posts: 15
|
I made a mistake...
Twenty years working on small and large engines alike and I finally made a fatal error tonight. It’s been a rough few weeks, so I’m not surprised. I changed the oil on my 5th gen and did my usual walk around to check for leaks after I was done. You can probably see where this is going. I f***ed up. Hard. Ran it for a solid minute and pulled it out of the shop without oil. The oil light came on as I was parking and I knew immediately what I had done. I’m angry, disappointed, and embarrassed. I didn’t hear any additional noise before/after I remembered to add the oil. Engine has 100k on it today. What should we set the over/under at before it goes boom? I plan to change the oil again first thing in the morning for a status check on how bad the shrapnel is...
Boys and girls always make sure you are in the right frame of mind while working on something.
Last edited by Cwright26; 10-02-2020 at 10:10 PM.
Reason: Grammar
|