Made a bit more progress today. Slow going for sure, but progress nonetheless.
Was able to rough in the driver's fender and rework the headlight mounts a bit to angle them lower. With the light adjustment close to maxed out the lights are low enough on the road and looking good.
I had to trim the bottom of the grill down a bit too to get it to mate to the new light position.
Tomorrow I will pick up some half inch spacers to start making mounting holes for the fenders. Hopefully the hood latch arrives early too because I still don't know if it will work or not.
Once I can finally pin the fenders in and hood latched tomorrow the idea is to then verify/adjust the gaps as needed and then turn my attention to the fender-door gap.
Sent from my SM-G970U using Tapatalk