Well, after doing a bit more research on the rear links and panhard bar my order with Front Range Offroad is cancelled and I have material coming from RuffStuff to weld up my own fully adjustable links.

I settled on 1.5" DOM tubing with .25" sidewall for the tubes and got their 3/4" high misalignment heims for both ends. If all goes to plan I should have a much more solid link than what I originally was upgrading to while also saving close to 200 bucks. My material total delivered ran right at $550 and the only additional stuff I may need is new hardware since these a heims are technically for 9/16" hardware.

There's a chance that I may have to end up enlarging the holes on the pick-up points, but I'm not opposed to doing that since I'm planning on reinforcing them with some 3/16" steel material anyway, at least on the lower ones that are prone to some rock damage. Can't wait, I've felt empty handed with all my fabrication projects complete, this will give me something else to weld up!

Oh yea, I also picked up some 1/2" MDF board to start building the rear drawer system that I am hoping to get started on this week at some point.