|
Senior Member
|
|
Join Date: Aug 2013
Location: Denver, Colorado
Posts: 1,041
|
|
Senior Member
Join Date: Aug 2013
Location: Denver, Colorado
Posts: 1,041
|
Quote:
Originally Posted by Bmnorm2
The last poly bushings I installed required grease and even provided a small packet of said grease. I believe it was silicone based grease.
Do you know if grease is required here and was applied by installer?
|
They Stongflex bushings that are on there came with a packet of silicone grease. I didn't do the install, but I'll assume they used it.
__________________
'13 TE w/ KDSS, 4:56 Gears, Dobinson's IMS C59-352/C59-701V, Sonoran Steel KDSS Trac Bar, Overland Custom Design Control Arms. Fuel Revolver 17x9 +1 mm 5" Backspace, Falken Wildpeak A/t3w 285/75r17, Hefty Fabworks Aluminum Front Bumper and Full Skids, C4 Fab Dual Swingout Rear Bumper, MetalTech OPOR Sliders, Northstar, Off-Grid Engineering, SPod, Blue Sea, Rigid, Baja Designs, KC HiLites, Stedi, Aplharex, National Luna, Drifta, Goose Gear, RAD Rubber Designs, Viair, Bandi Mount, URD, Gobi, ARB, Warn, Factor 55, Fourtreks, Axia Alloys, Desert Does It, Agency 6
|