Member
|
|
Join Date: May 2011
Location: Long Beach
Posts: 141
|
|
Member
Join Date: May 2011
Location: Long Beach
Posts: 141
|
Pulled a used (newer) drive shaft, what should I know?
Hey guys, I took my 99 2WD 4runner to a local shop who told me the shaking I've been experiencing is due to the driveshaft. Today I went to a local junkyard and found a 2001 driveshaft so I'm glad it's going to be a newer component. The ends may have been dragged in the dirt though while I was pulling it from the car. Anything I should do to it before putting it on the car other than brush off the dirt? Should I grease it with anything prior to installing it? All the guides I've watched show that I should mark the thing before removing to know how to place it back, since this is from another car, how would I know how it was supposed to go back in?
|