Member
|
|
Join Date: May 2019
Location: Denver, NC
Posts: 373
|
|
Member
Join Date: May 2019
Location: Denver, NC
Posts: 373
|
Kind of like a complete part out of the stupid wiring harness, which all weighs at least 30 lb. Just for fun we're going to weigh it tomorrow. I may or may not put the stock seats back in as well. I actually listed them for sale this morning here.
My entire dash was removed and we are going to build our own aluminum dash. It will have my Holley pro dash, vintage Air AC and heat. Most likely a large GPS screen and camera monitor and who knows what else this point. Think of a full ultra-4 or trophy truck dash. It should be something much less than what Morgan Clark does and closer wide open designs fj40 build.
I sold my Atlas and have purchased a new transfer case which I will detail later and of course, I have the new engine and transmission going in. My entire stock drivetrain and engine has been sold.
May also cut some of the front tube work, and rebuild it to get the full up travel my truck is capable of.
Of course we'll be rewiring the entire truck again and it will be far more simple than the stock wiring system and multiple computers.
Installing new steering, transmission and oil coolers, and a new 32 gallon fuel tank.
I will give much more detail moving forward as we are about to start putting it all back together. The remaining parts are starting to arrive.
Sent from my Pixel 8 Pro using Tapatalk
|