I took apart the the window switches and the ECT switches to swap LED's into them. Neither of these take a plug in bulb, the LED has to be soldered to the board on both.
Window switches taken apart:
Old bulb that needs to be cut off:
Here is the LED soldered into place; not the prettiest job but it works:
You can see them both lit up bright on the left side:
I just need to figure out the defrost switch and hazard switch to finish the whole conversion. I bought the wrong bulbs for those(they look right?) and took out the brake light fuse last night. Whoops. I ordered a few different LED's today so I'll post what the correct bulb is once I figure it out.
I also ordered an outside temperature sensor to replace the stupid effing clock with. No matter what I do to the damn thing it still works intermittently.
One last thing, I was curious what my coolant temps have been after overhauling the cooling system when I did the timing belt. Bought a cheap OBDII reader and am happy to report I haven't seen them go any higher than 192