Passenger window switch not working independently - Page 2 - Toyota 4Runner Forum

brillo_76 · 10-06-2023, 09:30 AM

Quote:

Originally Posted by chilipeppermaniac

I have a 2017 4 Runner Limited.

The car has basically only been driven every so often in the yard in the past 4 years. I have 32k on it and just got the title and began to drive it. All the switches work except the Main switch for the front Passenger window.

3 of the 4 main ones work, plus each switch on the corresponding doors. I tried the 5 minute, 5 second reset, but either did something wrong or it is something else. I will try again tomorrow.

Has anyone ever just had 1 switch that actually was a bad switch and can just the one be replaced?

Unfortunately, this is the 3rd gen section. So the information only pertains to 3rd gens 1996 to 2002. Might have in the 5th gen section...

Sent from my SM-A536V using Tapatalk

chilipeppermaniac · 10-11-2023, 09:10 PM

Quote:

Originally Posted by brillo_76

Unfortunately, this is the 3rd gen section. So the information only pertains to 3rd gens 1996 to 2002. Might have in the 5th gen section...

Sent from my SM-A536V using Tapatalk

Thanks Brillo.

I actually did find another place where some folks posted a solution. I am pretty sure it must be in a 5th gen place because the fix worked.

This one was to Use the switch on the actual door and put the window down, then hold the switch down for 10 seconds. At this point, the driver's switch for this door began to work again.

Tigersquid · 02-13-2024, 01:16 PM

Quote:

Originally Posted by shadow247

Try this.

First disconnect the battery, let it sit for 5 minutes, and reconnect.

Now turn on the ignition, but do not start the engine.

Push down on the passenger window MAIN SWITCH only for 5 seconds.

Pull up on the Passenger window Main Switch only for 5 seconds.

This should reset the switch module. I had to do it on mine after I left the dome light on for a few weeks and drained the battery.

Looking through older posts and came across this. Will this work for a 2005 4runner also? The windows will work intermittently from their respective window controls. However they all work without issue from te drivers panel. For example most of the time my passengers will be able to roll down their window but I will have to roll it up for them. Or sometimes it will be in reverse where I will have to roll it up for them.

4runnerbl · 05-06-2024, 01:13 PM

Quote:

Originally Posted by shadow247

Try this.

First disconnect the battery, let it sit for 5 minutes, and reconnect.

Now turn on the ignition, but do not start the engine.

Push down on the passenger window MAIN SWITCH only for 5 seconds.

Pull up on the Passenger window Main Switch only for 5 seconds.

This should reset the switch module. I had to do it on mine after I left the dome light on for a few weeks and drained the battery.

2016 Limited

My battery went bad and when I installed new battery driver side panel would operate all windows except front passenger window. Everything else worked properly. I went through these steps and it worked perfectly. Thank you for this information.
One note. I interpreted the MAIN SWITCH to mean the button on the driver side panel. That did not work, but doing this with the switch on the passenger worked perfectly. That is my misunderstanding, but thought I would clarify for any others as ignorant as me. Thanks again.

Site Navigation