Hi guys, I am new to the forum, so I hope I am posting in the right area! Anyways, ever since I put on my Sonoran Steel lift kit (3" front, 4" rear) my vehicle stability control has been going nuts! It used to be only on right hand turns. After researching, I found that there is a way to calibrate the VSC system and the yaw sensor by using a jumper on some pins in the diagnostic port. I followed the instructions, and I believe that the system must be calibrated now because not only does my sensor beep on right turns, but it now also beeps on left turns!
I am not driving crazy by any means. I drive windy mountain roads every day, and on turns where people are passing my at 50mph, my sensor is going off at 40mph (speed limit is 50). If I go a little too fast (very slow relative to everyone else) then the system will lock up my brakes, and it almost sent me careening into the wall barrier on highway 17. At times, I could not even pass a big semi truck because the vehicle would start going nuts.
Is there anything else I can do? Does anyone else have this problem?