Quote:
Originally Posted by nissanh
I measured the diameter of a new bolt that goes into the flange and it is 9.91 mm (0.39 inches)
Length of the threaded part of the bolt is 36 mm (1.417 inches)
25.4 mm = 1 inch
Socket is 14 mm
Bolt flange = 90080-10064
Nut: 90080 - 17187
|
That would be an M10x1.25. If the first two digits of the second half of the p/n are 10 or 08, say, then those are M10 or M8. Same for many nuts and washers. Toyota only uses one thread pitch for each diameter:
Quote:
6mm diameter - 1 mm pitch (iso course) - requires 10 mm wrench to fit head / nut
8 mm diameter - 1.25 mm pitch (iso course) - requires 12 mm wrench to fit head / nut
10 mm diameter - 1.25 mm pitch (iso fine) - requires 14 mm wrench to fit head / nut
12 mm diameter - 1.25 mm pitch (iso other) - requires 17 mm wrench to fit head / nut
14 mm diameter - 1.5 mm pitch (iso fine) - requires 19 mm wrench to fit head / nut
16 mm diameter - 1.5 mm pitch (iso fine) - requires 22 mm wrench to fit head / nut
|
__________________
'99 4Runner SR5 5spd 3.4L V6 4WD(U.S), original '99 Talls in front, OME 906s in back, Hella fogs, Trekmaster shocks in front, Billy in back, no running boards, FIAMM horns, Alpine sound, Michelin LTX M/S2's, owned since new.
'97 HiLux SW4 5spd 4WD(Japan model bought in Brazil assembled in Argentina, very close to a 3.0 4Runner/Surf)
'71 FordWillys Jeep CJ5 (with straight six Ford Maverick 3.0 liter engine--lives in the mountains north of Sao Paulo Brazil)
My Backyard Frame Swap