Quote:
Originally Posted by Vette468
Anybody thats done aFord 8.8 swap ..did you have to Buy Cut to Fit axles with the correct lug pattern or whats the Solution..im doin Seals n bearings for the first time..but found a 8.8 for $25bux ..gotta Plan  ! |
One big question for you here: Why would you swap a different axle in that is weaker, would require a decent amount of fabrication to mount, would require either special 6x5.5 axle or adapters, require changing the rear brake/parking brake system, require a custom driveshaft, and require the front diff and rear axle to be regeared to a matching (or close) ratio?
Second smaller question/suggestion: Maybe start
ONE new thread instead of starting a new thread for each of your questions. Or maybe try asking in this thread:
The 3rd Gen All Questions Allowed Thread Do you really need a new thread for every question you have?
Edit: Try using this google 3rd gen specific search:
site:toyota-4Runner.org/3rd-gen-t4rs/ - Google Search
__________________
2000 SR5 V6 Manual 4WD
https://www.toyota-4runner.org/3rd-g...biography.html
2000 Limited V6 Auto E-Locker Sold 3/2022
Hot Rodder Car Nutt- Enthusiast for over 35 years! Biker -Builder ..Amateur GunSmith-Amateur Explosives Expert-Expert P%ssy LicQer
... E-Lock Grey Wire Mod. Rough Cunt' 3'Lift' Dick Cepek DC2s- 16x8' -12 offset" 285 75 16' IRONMAN MUD COUNTRY's ' ,On-Board Air,"EngineStand Tire Carrier" 12,000lb'winch'-DualBatterys
Linear Mode
