Hello all,
I know I am not too active on this forum; however, I figured this is going to be the best place to go to get some input...
Backstory
I am throwing dual ARB air lockers (ARB RD90 + RD132) on my 2000 SR5 & going to 4.56s (Yukon front, G2 rear). I am a stickler for OEM parts/switches/etc.
This led me to the idea of using an
80 series e-locker switch for the front/rear lockers. I plan on deleting my cigarette lighter plug and retrofitting the switch to fit in that hole so it is non-obtrusive. I have seen someone w/ a
100 series use an 80 series switch to run his dual air lockers, so I know it can be done...
What I want to do/need help figuring out
What I am looking to do is have my RR Locker light engage when I turn on the locker. I know my air lockers come with harnesses, but they wouldn't run the same way the
e-locker harness (see link for diagram) runs. What I'm asking here is: what additional wires do I need to purchase from Toyota to make this work?
Moreover, are there any diagrams around for running dual air lockers solely off of the 80 Series locker switch? The switch itself is a 3-prong switch. As seen in the video included above, it can be done. I just can't figure it out since I am somewhere between novice/intermediate with wiring.
TLDR
What do I need to do to make an 80 series switch solely run both air lockers in a 3rd gen while also turning on the RR Locker light in the dash???
Thx in advance!
Also, I am active on IG
@
Griffin4Runner
if you want to watch this build in real-time