|
Member
|
|
Join Date: May 2020
Location: Ontario
Posts: 424
|
|
Member
Join Date: May 2020
Location: Ontario
Posts: 424
|
A buddy put one on his 04 Taco, Curt I think, and a superwinch hitch mount, he never used it, a bit of bear to put in when needed, but it works, and you do have access to the skid plate for servicing. I wouldn't weld it, the bolts are stronger than welds, although there's not much to the tow hook square tacked on nut inside the frame. I tucked a warn M8000 right under the bumper, lots of room, mounted to some transport frame cut up to slip over the frame rails and bolt up, I also add metal to the front frame inside and tacked the nuts in place for added support, you going to have a lot of leverage with a hitch mount winch hanging that far out from the frame rails IMO, so careful winching.
crumple zone, 4Rs don't crumple they bounce but I guess it depends if you have fatlip bumper or the regular old school bumper without crush cans
__________________
99' Ltd E-locker grey wired, 4R Bilstein 5100, 99 tall coils, 906 OME & 1.5" spacers, 2015 4R Trail Edition 275/70R17, 1" RB BL
97' SR5 E-locker grey wired, Warn winch, 2" RB BL, Sonoran Steel 1.2 lift, dual battery, 1000W inverter, Hydraulic Arctic plow, 12" x 33" Baja Claw
92' Eclipse GSX AWD 6/4 bolt combo, 28 PSI boost, Meth injection, 750cc injectors, FMIC, 2.5" IC piping, full 3" exhaust, 350AWHP, lowered, Alum flywheel, 6 puck Clutch, Cams, JDM gear set,VC rear diff, EPROM ECU
Last edited by Malcolm99; 11-05-2020 at 06:48 PM.
|