I bought the bushings and arms from partsouq.com. Even with shipping it was much cheaper than buying here. Order Saturday and I get all in front of my door by noon Wednesday. Make sure when ordering, the parts are in stock, if not, you'll see 7-10 days wait time marked next to the part.

First time posting. what's up everyone. Wow this site has been so helpful in so many ways! Appoligies if this has already been confimred and I just missed it.

I am also replacing on 1997 SR5 runner the FRONT UPPER/LOWER control arm bushings and wondering if the list listed below did fit properly? HOPING ORIGINAL POSTER CAN CONFIRM...

TLDR but maybe useful

Found this list after I was researching here on other T4R threads and there seems to be different opinions on which ones are preceisely needed. I have cross checked from toyota OEM part sites and part numbers, as well as seeing some parts sites are listing similar to list below but not 100%

I have already purchased the parts and would rather double check with poster or others so I dont have the vehicle down for a long tiime, primary vehicle and only have weekend as we all do.

SAME Upper/Lower Control Arm bushings I ordered, sitting and ready for install:
-----------
FRONT:
48061-35040 Bush Lower - Front (Two bushings)
48061-35050 Bush Lower - Rear (Two bushings)
48632-35080 Bush Upper - Four Bushings
-----------

My toyota OEM parts recieved in bags labled, which we all know can be edited...

-----------
FRONT LOWER Control Arm: same as above
48061-35040 Bush Lower - Front (Two bushings)
48061-35050 Bush Lower - Rear (Two bushings)
Damn they are almost identical in bolt hole size, Length and width. As posters have mentioned the front are the 35040 and the rear are the 35050.

Confirm?!

- MICROMETER ORDERED DUE OLDER EYS ON TAPE MEASURE LOL

-----------
FRONT UPPER Control arm: same as above

ALL FOUR UPPER FRONT/BACK are the same?!
48632-35080 x4 are smaller in diameter for sure (Amazon and Ebay has listings for all upper as the 35080#)

Confirm?!

-----------

Toyota parts site is different and show a Upper Control Arm Rear Bushing and 48635-35010 x2 instead of x4 35080.... So many questions but it also shows Upper Control Arm Front Bushing 48632-35050 x2

Thank you for anyone that can confirm, it would so aappreciated!

D

Well.. all the parts I have listed for my 97 4x4 SR5 works 100%. It has been some time and not sure about the bolt holes, but if you get the exact parts, then you should be fine. Make a note of how the rear lower bushings are pressed into the arm. There is an arrow and that should point to the front and the air gap is placed parallel to the control arm (arrow will then point to the front): Last two pictures in post-8.
Also check with parts diagram given in the partsouq.com