I ordered Tundra 13WL calipers, rotors and pads from RockAuto - Cardone 19-P2712 and 19-P2713. I was ready to bolt the calipers back on after cutting the dust shield and the bolts don’t go all the way back in. Secondly, the caliper doesn’t look centered over the rotor even if the bolts did tighten down.
The OEM mounting bracket is 19.25mm thick, and the new calipers are 16.75mm thick, leaving the bolts to stick out. The bolts stick out 18.8mm when all the way in on their own.
Edit: None of the caliper mounting holes were tapped all the way through. There was at least 1/4” of threat to cut.
Outside clearance is tight.
Inside looks fine.
What’s going on here?? I confirmed that I was sent the right P/N’s.