Hello all,
Tomorrow I will be wiring up an "EXTREMELED X6S SLIM AMBER/WHITE" light bar. I have never wired anything like this before, though I do have some knowledge in wiring/electric.
I'm asking for some quick help before I begin tomorrow to hopefully make this go a lot smoother.
For starts - i'm wiring it up using the "UV100 Voswitch 8 Gang Switch".
(Here's the product
Amazon.com: Voswitch UV100 8 Gang Programmable Switch Panel Power Control System for Truck UTV Side by Side Boat 12V Battery Use: Automotive)
So, here is the wiring diagram they gave me.
My question is, since i'm using the Voswitch with 40Amp relays built into it, do I simply just need to cut the wiring harness from the light bar short to right behind the relays? I noticed it has a "remote receiver" further down the line which I don't think applies to me, it is just a male and female plug that's connected. If I cut it behind the relay will I lose my ability to use one or the other color (just amber/both amber and white)? And if so, is there any way to wire it to keep the ability to run both?
Quick Idea: The wires from the light bar to the relay are a RED(positive) BLUE(positive) and yellow(negative). Could I simply cut behind the relays, and extend these three wires to my Voswitch? Since the Voswitch does not have grounds, I would have to run the yellow (negative) to the body for ground, then could I simply run the red to one switch on the Voswitch and the blue to another switch on the Voswitch?
Thanks in advance