i recently rolled my 3rd generation when i was up in the hills with some friends while it was snowing/raining...ended up rolling three times, landing on the drivers side, had someone flip it on its wheels, checked all my fluids and it started first try and drove it home at 6 AM...
what a night...

so i have a lot of work to do, i need new fenders, a grill, hood, i need to replace the roof between the windshield and sunroof, pull some dents out, replace the windshield and the rear driver side window, but thats about it...

here are some pictures...


the roof


and the window

i found someone that would help me with the roof, that had done something similar to this already, and i want to get some flared fiberglass fenders and i'll need a new hood, so i saw this picture and thought it looked clean, any help on where to get a tacoma front clip or how to do this or if it is hard...



thanks for any help

It looks to me like all that was done to that 4runner for the Tacoma stuff is they swaped out the hood, front fenders and grille with Tacoma ones. Considering that the front end of a Tacoma and a 4Runner are pretty much exactly the same I bet it would all just bolt right on.

Your 4runner looks pretty sick in the sig picture. But man that sucks, i hope your ok!

thanks mann

is there anywhere i can get the tacoma clip or would i have to find a tacoma to get it off of?
i found the hood and fenders from glassworks already...

www.car-parts.com find a salvage yard that shows most of the parts used, and see if they have the whole thing that they can make you a deal on.

what year tacoma would i be looking for?
cause i think they are off set from T4R's, but i might be wrong...

probably a dumb question but does anyone know if a new tacoma front clip would fit on a 3rd gen T4R? cause its more flat at the top, like my stock grile, than the one in the pic i showed above...