This is a gen4 bumper that was the proto type of the design Luke is doing now.
It sits out side, just swing by and you can have it when he's not there. LOL, joke.
I took these pictures incase I needed reference as no install directions.
He seen some things I have done/built on my ride and figured I would have no problem.
All attachments that are listed in his web site are available for this bumper also. He also designed the jerry can holder that can be removable, and attaches to the latter assemble. I didn't buy any extras as I'm going to do my own. I told him I was going to the Jerry can holder on the latter, he said like this, yea like that. His last words where great mine think alike.
The sections below the tail light will need some cutting down. Don't think your getting a kit that are just butt and weld( for warning). Have metal cutters, band saw, grinders ready. You will need to do some pulling, propping to put this together. Yes I have fabricating experience is why I say this.
The tube section you might have to play around with, push and pull the sides, but sits about 1/4" below the body line.