I need advice from those that have installed these white knuckle sliders! I install the passenger side no problem. But this driver side I think I did something wrong ? The rear upper brake line clip I was able to do, but I can’t seem to figure out the center U bolt . Following the instructions my center u bolt doesn’t line up at all. I don’t see how I can push the slider forward anymore for it to line up ? See below ;
Center u bolt pictured location per instructions
The location of my slide in relation to the u bolt
Are you guys unclipping the side brake lines (circled in green) and leaving them unclipped ?
I don’t see how I can slide them anymore forward as they would touch in the front
and rear
Any advice would be appreciated !
Sent from my iPhone using Tapatalk