Quote:
Originally Posted by awhitney1
I had to get my bolts retorqued and had the gaskets replaced at the end of the y-pipe. Not sure how bad the gaskets were before hand, but after retorqing the headers stud bolts and gaskets at the end of the y-pipe, all was good
|
Nice, I went out and crawled under the truck this morning. One of the bolts was so loose it'd almost come off. Only looked at one side but I'm hoping tightening them down is all I need to do.
Spoke with Doug Thorley about which gaskets I'd need. They are under new ownership and said they would need the part number located on the flange.
Anyone have our specific part number for these just to have on hand?
Also, does anyone know what the torque specs? Didn't see it in the instructions.
Thanks!
__________________
05 V8 Limited - Titanium Metallic -
Build Thread
Gobi Stealth rack | King 2.5" Coilovers | Custom length 2.5" King rears | Insain Fab BMC | SPC UCAs | AIP bypass | SCS Ray 10s | BFG KO2s | RCI aluminum skids | RCI sliders | ARB Dual Compressor | ARB Diff breather | DT long tubes | Custom y-pipe | Gibson cat-back