Hello all,
So, I got an OEM Nav h/u EONS AGO and because of the newfound time I (most of us) have, I decided to take out the "box of mods" that have been sitting in my basement. Anyway, Made wire looms and whatnot, but I've been stumped on how to wire the OEM microphone. I know the following:
I have the "pin-outs" on how to connect it.
Here is the microphone:
Anyway, as you can see, on the H/U, I know what pins to use, BUT, on the microphone itself, I only have morsel of information.
So, the 3 wires at the end of the 6 pin plug are: at least I THINK:
red wire = MACC (microphone power)
black wire = MIC-
white wire = MIC+
According the pinout diagram above, MIC- (I think black wire) has to be attached to pin20 AND attached to the wire shield. Some thread don't mention the wire shield at all. Anyway, what to do? Attach to the shield as well or not?
Also, I just can't find a pin out (wire diagram) to the microphone (p/n: 86730-35020), can anyone verify that the above is correct ? I don't want to short anything. Thanks
calling out those who have done this:
@
bluemotev
@Koz
@
j0mama
@A/V1