Member
|
|
Join Date: Feb 2011
Location: Raleigh, NC
Posts: 54
|
|
Member
Join Date: Feb 2011
Location: Raleigh, NC
Posts: 54
|
Battery died now cam & crank sensor faults
So, I left my headlights on and ran the battery down. After jumping it and driving it around 20 minutes, it seemed fine but the check engine light and RSCA and Trac off lights on. After driving some more and shutting the car off and on, they finally went out. But when I used my plug in oBDII reader, I'm getting the following codes: PO 335, PO 340, PO345, PO 335. I don't understand why running the batter down would cause this. Is it coincidence? Why would both crank and cam shaft sensors go at the same time. Care has 240K.
Also, I"m having trouble locating where the crankshaft sensor is located on the V6.
They say if these sensors are bad, the car will just fail to start in a few cycles. I"ve already shut it off and on 5 times today w/o problem. Do I need to take it out of service until I can fix this?
Thanks in advance.
|