Hi Folks,
My 2005 driver's side rear door moulding was partially removed by a car wash. I know, I'm never going to another one again that's not touchless.
Anyway I had to remove the seal that runs up the back of the door to epoxy the rivet holders back into place. Now I'm reassembling everything and the seal is attached to the moulding with rivets and two-sided tape. The panel itself is also partially attached to the body with double-sided tape.
I bought this
3M Exterior Attachment Tape but it didn't adhere very well. I've gotten some denatured alcohol to clean the surfaces and I'll try again.
My questions are:
1. What double-sided tape (or other adhesive) have you folks used for this purpose?
2. What did Toyota use at the factory?
3. Any tips?
Thanks.