10-24-2023, 09:50 PM
|
#1
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
JBL Sub-Woofer Replacement Suggestions
Sub-woofer in my new to me T4R is blown. What driver are you guys using for replacement?
|
|
Reply With Quote
|
10-25-2023, 04:18 PM
|
#2
|
|
Senior Member
|
|
Join Date: Dec 2018
Location: New Hampshire
Posts: 1,207
Real Name: Mike
|
|
Senior Member
Join Date: Dec 2018
Location: New Hampshire
Posts: 1,207
Real Name: Mike
|
There's a few threads out there if you search subwoofer within this forum. I think I recall people installing Pioneer. You could also go to Crutchfield and punch in your car info. These seem to fit mine, may be the same for yours.
8 Inch Subwoofers at Crutchfield
__________________
Mike
03 4runner Limited
1GR-FE V6 w/199k miles
|
|
Reply With Quote
|
10-27-2023, 11:18 AM
|
#3
|
Member
|
|
Join Date: Dec 2010
Location: SC
Posts: 253
|
|
Member
Join Date: Dec 2010
Location: SC
Posts: 253
|
I went with the Kenwood XR but honestly if I had to do it again I would have gone with the cheap amazon sub instead, you're really not going to get much out of an 8" in that enclosure.
I also used the lazy hot knife cut instead of removing the whole side panel and its been holding up fine for last 4 years, you cant even tell it was cut out.
__________________
'99 SR5, 2007 Sport
|
|
Reply With Quote
|
10-27-2023, 07:06 PM
|
#4
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Quote:
Originally Posted by twa318
I went with the Kenwood XR but honestly if I had to do it again I would have gone with the cheap amazon sub instead, you're really not going to get much out of an 8" in that enclosure.
I also used the lazy hot knife cut instead of removing the whole side panel and its been holding up fine for last 4 years, you cant even tell it was cut out.
|
"Hot knife method"? Interesting. I pulled the side panel which should have been easy except for the knob plastic connector. Stock sub is dual coil. Both VC's measured about 7.3 Ohm which I think is good. Surrounds were gone but the driver should have moved with signal. I replaced both head unit and amp with same result. Hmmm.
|
|
Reply With Quote
|
10-27-2023, 08:42 PM
|
#5
|
Member
|
|
Join Date: Dec 2010
Location: SC
Posts: 253
|
|
Member
Join Date: Dec 2010
Location: SC
Posts: 253
|
Very easy/lazy method, just take a knife, heat it up, cut out the surround. I used a folding husky box cutter knife with a fresh blade.
With a clean cut the mesh surround just pops right back in. A few forum threads detail the process.
Downside is you lose protection for the sub from objects being thrown around in the cargo area but I keep a ton of crap back there and never had an issue. Also easy access in case sub goes out again in the future.
__________________
'99 SR5, 2007 Sport
|
|
Reply With Quote
|
10-27-2023, 09:08 PM
|
#6
|
|
Member
|
|
Join Date: Jul 2017
Location: Valley of the Sun
Posts: 228
|
|
Member
Join Date: Jul 2017
Location: Valley of the Sun
Posts: 228
|
I went with a Rockford Fosgate P3SD2-8 when mine blew. I have no complaints what so ever about it. Great little sub with good lows, mids and highs for just the right price.
__________________
2006 V8 Limited 4WD
| Doug Thorley Headers | Gibson | Old Man Emu | ToyTec | SPC Performance | RCI Metalworks |
| Skid Mark 4x4 | SpiderTrax | BFGoodrich KO2 | aFe | Rutech | HCF Mod |
|
|
Reply With Quote
|
10-27-2023, 10:25 PM
|
#7
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Quote:
Originally Posted by 0verland
I went with a Rockford Fosgate P3SD2-8 when mine blew. I have no complaints what so ever about it. Great little sub with good lows, mids and highs for just the right price.
|
Oooh. I just looked at photos. It's 2 Ohm rated so a tough load for amplifier. Can our stock amp handle this? And what about mounting? I see four mounting holes in the sub photo while our sub box has six.
|
|
Reply With Quote
|
10-27-2023, 10:29 PM
|
#8
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Quote:
Originally Posted by twa318
Very easy/lazy method, just take a knife, heat it up, cut out the surround. I used a folding husky box cutter knife with a fresh blade.
With a clean cut the mesh surround just pops right back in. A few forum threads detail the process.
Downside is you lose protection for the sub from objects being thrown around in the cargo area but I keep a ton of crap back there and never had an issue. Also easy access in case sub goes out again in the future.
|
The sub-panel that covers the sub is in theory removable but it has a hot weld in the back to hold it in place. (This sub-panel does not have a grill opening for non-JBL optioned trucks.) If this panel can be made to open on demand, that would give plenty of access to the sub cover. It would look totally stock and not compromise protection.
|
|
Reply With Quote
|
10-31-2023, 03:15 PM
|
#9
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Thanks for the replies. I ordered Pioneer TS-A2000LD2 from Amazon, $65 shipped, includes $60 coupon for signing up for Amazon Shop card. This sub has 6 screw mount so easy install. I cut out the plastic welds for the sub cover. Cover pops back into place and is friction held but the mounting posts. Not ideal but it stays in place.
Last edited by SocalSam; 10-31-2023 at 03:32 PM.
|
|
Reply With Quote
|
10-31-2023, 06:48 PM
|
#10
|
Junior Member
|
|
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
|
Junior Member
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
I bought a Pioneer TS-2000LD2. I understand why it's a popular sub but it just doesn't do the job for me. I'll replace that one a little while down the line
|
|
Reply With Quote
|
10-31-2023, 08:27 PM
|
#11
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Quote:
Originally Posted by benostler33
I bought a Pioneer TS-2000LD2. I understand why it's a popular sub but it just doesn't do the job for me. I'll replace that one a little while down the line
|
What did you not like? Did it sound like the stock woofer, which I have never heard. I'm not looking for a competition sub. I just want the rear channel to sound normal-ish, whatever that is.
|
|
Reply With Quote
|
10-31-2023, 09:15 PM
|
#12
|
Junior Member
|
|
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
|
Junior Member
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
Quote:
Originally Posted by SocalSam
What did you not like? Did it sound like the stock woofer, which I have never heard. I'm not looking for a competition sub. I just want the rear channel to sound normal-ish, whatever that is.
|
I never heard my stock sub because it was blown when I bought the car. Don't get me wrong, it's a good sub, but it is not what I was specifically looking for (because i'm an audiophile lol). I listen to rap music, and this sub doesn't play the low bass very good. Everything else it's perfectly fine.
|
|
Reply With Quote
|
10-31-2023, 10:38 PM
|
#13
|
Member
|
|
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
|
Member
Join Date: Oct 2023
Location: SFV, Calif.
Posts: 170
|
Quote:
Originally Posted by benostler33
I never heard my stock sub because it was blown when I bought the car. Don't get me wrong, it's a good sub, but it is not what I was specifically looking for (because i'm an audiophile lol). I listen to rap music, and this sub doesn't play the low bass very good. Everything else it's perfectly fine.
|
I don't think any rap fan rocks an 8 inch sub. I went to a stereo installation shop to see if they had something off the shelf and they laughed at me. Anyways, based on your other words, I think the Pio will be fine.
|
|
Reply With Quote
|
11-01-2023, 06:20 PM
|
#14
|
Junior Member
|
|
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
|
Junior Member
Join Date: Sep 2022
Location: Fort Worth, TX
Posts: 7
|
Quote:
Originally Posted by SocalSam
I don't think any rap fan rocks an 8 inch sub. I went to a stereo installation shop to see if they had something off the shelf and they laughed at me. Anyways, based on your other words, I think the Pio will be fine.
|
Yep, that's my next move lol. I thought that's all I needed to do because my other car (2009 mercury mariner) has the single greatest factory sound system of all time. Haven't been in/driven a car with a better factory sub
|
|
Reply With Quote
|
11-03-2023, 04:44 PM
|
#15
|
|
Member
|
|
Join Date: Dec 2003
Location: Washington
Age: 50
Posts: 787
|
|
Member
Join Date: Dec 2003
Location: Washington
Age: 50
Posts: 787
|
What are you hoping for with the replacement? Are you going to replace the factory amp too?
When my sub blew, I decided to redo the entire system. I went with a Fosgate
T1 10inch. Running off of a Fosgate T1000x5. Made my own enclosure for it and I cannot believe how much better this sounds. I was totally impressed that it performs the way it does.
Been in there 2 years now, working great.
More images in the link in my sig of the system as I was putting it together.
__________________
Check out my 2004 4Runner Audio upgrade.
|
|
Reply With Quote
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is On
|
|
|
|