LED Turn Signals - Toyota 4Runner Forum

connorwongtellem · 07-20-2011, 08:04 PM

I've replaces most of my incandescent bulbs with LED's and I also replaced my turn signals and I rea that they might hyperflash and they did. I was wondering is hyperflashing bad and if so why? And how can I fix it and how would that work.

HOJeepster · 07-20-2011, 08:19 PM

You need a resistor to control the blink rate.

gaterose · 07-20-2011, 08:22 PM

you can also buy a new flasher from superbrightleds for $25 I think.

I don't believe it will hurt anything but it is annoying when they blink too fast.

Capt246 · 07-22-2012, 12:09 PM

Which wire to you install the resistor on?

Whitebeauty · 07-22-2012, 03:33 PM

Quote:

Originally Posted by connorwongtellem

I've replaces most of my incandescent bulbs with LED's and I also replaced my turn signals and I rea that they might hyperflash and they did. I was wondering is hyperflashing bad and if so why? And how can I fix it and how would that work.

If u want to take a pic of your flasher to verify compatibility i can hook u up. But be sure u check it before u think about ordering one....what yr is your truck? If u want resistors i can help u with that as well.

Resistor installation: quite simple one wire on one and the other on the other.

kman79 · 09-18-2012, 07:43 AM

Quote:

Originally Posted by connorwongtellem

I've replaces most of my incandescent bulbs with LED's and I also replaced my turn signals and I rea that they might hyperflash and they did. I was wondering is hyperflashing bad and if so why? And how can I fix it and how would that work.

I would like to replace the rear turn signals to LEDs and was wondering where you purchased them? The size is 992 or 7440A correct?