Quote:
Originally Posted by Stifler
and the benefit to this would be? I mean it was a popular mod in the Jeep world but I'm not sure what the benefit would be on the 5thgen as they are so new...
|
I agree, for 5th gens its not a very big deal. But if its going to be like the 4th gens are right now. Its 10yrs and the only body mounts you can get are from Toyota and for a full set with hardware its over $600. My body mounts on my '04 are starting to deteriorate at about 10yr/110k. Not to mention those of us who are doing a body lift later down the vehicle's life may want to swap them out while doing it.
Quote:
Originally Posted by Danimal
Poly body mount bushings on my 3rd gen 4Runner had a very negative impact on NVH. They transmitted much more road induced vibration as well as engine noise and vibration, and generally made for a lousy driving experience. I'll never go that route again.
Dan
|
A few of us mentioned it the thread that it would have to be a softer durometer most likely. Body mounts shouldn't be too stiff in my opinion as you said it would make the ride more unbearable. But I would also venture to say that the technology between the 3rd gen and J120/J150 vehicles is a bit better.