We have been working a lot behind the scenes to do more test fits and measurements on a few more vehicles. The results we are finding is that there are some pretty good variations in both the plastic mold and frame horns when being built.
So, we are making some adjustments to the frame horn mounts to allow a bit more movement to allow install across the variations. Keep in mind this will work in most cases and there may be some instances where the horns deviate a bit more than expected and may need to have the holes opened up slightly more to accommodate that.
We will be including the shims, as seen the attached pdf document, with every bumper. This will allow for the installer to space out the bumper in 1/16" increments to clear the plastic. Not all installations will require the shims, but every bumper will be shipped with these.
If you already have a bumper and need the shims, please email me directly at
[email protected] with an address and information on who you ordered from and I will get you these sent.
We thank those of you who have reached out and helped us resolve some of these issues and like all of our products, we will always strive to make them the best possible and do listen to feedback.
Thank you.
Armando