Quote:
Originally Posted by clintg
A simple solution for adding the terminals is to fold over the end of a new solid wire (opposed to stranded). The folded end supposedly locks into the connector cavity similar to a terminal. I wouldn’t consider this a permanent solution, but perhaps is sufficient to prove that you bcm will react to the sensor as expected.
The iDatalink t-harness is the only “proper” solution I know of.
|
The folded wire thing is a kludge. Never gonna happen in one of my vehicles.
I've already ordered the iDatalink t-harness from Best Buy. Thanks for the tip on that! And it seems that I already have the wires to the light sensor itself, but I haven't looked for the FG1 connector yet. My guess is that it's a dead end. I'll probably just end up tapping into the light sensor's wire harness (between the sensor and FG1) and running a jumper over to the new T-harness.