Help request for Daystar Lift - Front Brake Bracket - Toyota 4Runner Forum

generald · 06-22-2020, 12:58 PM

Hi all,

After lots of searching, I cannot find a solution.

Vehicle: 2016 4Runner Limited (with XREAS)

Spacer Lift: Daystar, Toyota 4Runner 2.5" (front) + 1.5" (rear) Lift Kit (Model: KT09134BK)

Issue: Front brake line bracket that attaches to vertical arm does not align with bolt holes. Issue appears that the hard brake lines are preventing alignment. Pictures below.

Attempts: Jacked up the lower control arm to change the angle, no improvement.

May I please ask for your help -- any ideas?

Thank you in advance, T

MyanRagahis · 06-22-2020, 01:12 PM

Kind of looks like it got straightened out.
Here is what mine looks like. More of a bend to it.

pDubs · 06-22-2020, 01:16 PM

You should just be able to move it with your hand and put a slight bend in the hard line.

generald · 06-22-2020, 01:22 PM

Really appreciate you both. Been a tough weekend and your pics+feedback is that support I needed. Will get back to it tonight.

Many thanks, T

Quote:

Originally Posted by MyanRagahis

Kind of looks like it got straightened out.
Here is what mine looks like. More of a bend to it.

Quote:

Originally Posted by pDubs

You should just be able to move it with your hand and put a slight bend in the hard line.

Sniper4690 · 08-17-2024, 09:13 PM

Quote:

Originally Posted by generald

Hi all,

After lots of searching, I cannot find a solution.

Vehicle: 2016 4Runner Limited (with XREAS)

Spacer Lift: Daystar, Toyota 4Runner 2.5" (front) + 1.5" (rear) Lift Kit (Model: KT09134BK)

Issue: Front brake line bracket that attaches to vertical arm does not align with bolt holes. Issue appears that the hard brake lines are preventing alignment. Pictures below.

Attempts: Jacked up the lower control arm to change the angle, no improvement.

May I please ask for your help -- any ideas?

Thank you in advance, T

I'm sorry to revive quite an old thread but I've been trying to figure out what that bolt is that attaches that bracket to the arm like that. I just replaced my front brake pads and rotors and one of them screws stripped out and I've been looking everywhere for it. I own a 2020 4Runner

generald · 08-17-2024, 10:52 PM

Quote:

Originally Posted by Sniper4690

I'm sorry to revive quite an old thread but I've been trying to figure out what that bolt is that attaches that bracket to the arm like that. I just replaced my front brake pads and rotors and one of them screws stripped out and I've been looking everywhere for it. I own a 2020 4Runner

I think it’s an M8x20

See Part number for brake bracket bolt?

You could retap it for whatever tap you have one or two sizes larger.

Sniper4690 · 08-17-2024, 11:35 PM

Oh man thank you so much! I've spent so long trying to find out what that bolt is. I think I might have that on hand since I went to O'Reiley's and they helped me out as well (I just haven't tried them yet because it was a fairly long day). Might get a few extra though and probably a tap and die set too while I'm at it.

Site Navigation