Hey guys. I just installed a new wheel bearing assembly from bluepitbearings and all went well until I noticed there's a gap where the CV axle meets the assembly. I found a couple of threads on this but no resolution. I used an impact on the axle nut so it's definitely tight. I'll try again tomorrow but wanted to put this post out there.
Anyone encountered this and how did you resolve?
[IMG]
CV Axle Issue
[/IMG]
__________________
2011 4Runner Trail - Bilstein 5100s set @1.25" front and Cornfed 1" rear spring spacer, Magnaflow 12586 muffler, TRD Intake, Yakima Loadwarrior w/ Extension, Spidertrax 1.25" Spacers
40-60mph run-up
http://youtu.be/wWkRZx6Q-l4
Cruisin' for the weekends!
Linear Mode
