34x10.50r17 Toyo AT3 - Page 2 - Toyota 4Runner Forum

T4Jumper · 11-15-2022, 03:48 PM

Wow, this is very intriguing. I would love to see a few more pictures of different angles. Have you tried flexing it out yet to see if it rubs the body mount then?

I love the idea of this tire size because I'm a huge fan of running stock wheels and being able to clear the UCA without spacers is awesome.

4Brewz · 11-16-2022, 02:23 AM

Quote:

Originally Posted by JLtoTRD

Did you need to run and wheel spacers?

Negative. I had some on hand, but they tires cleared the JBA arms on stock pro wheels by about an inch. I was very worried it would run but don’t.

I think if I did through on my 1” spydertrax, I do think it may run on the body mount. It’s close as it is, so pushing it out I think it will hit.

So no, no spacers on stock pro wheels.

4Brewz · 11-16-2022, 02:28 AM

Quote:

Originally Posted by JLtoTRD

BFGs are notorious for running small so even though they say 34" I guarantee they are a "large" 33".

These are Toyo, but ya same story. Unmounted they were 33.5 to start. Mounted, about 33. And then on the vehicle with weight at 32psi I get right around 32.5” with a level.

So 34 becomes a 32.5 mounted under load. Definitely running small here as the BFGs did. But, knew that going in and ok with that myself. I don’t. Think they would fit as a true 34 without a BMC at minimum.

4Brewz · 11-16-2022, 02:29 AM

Quote:

Originally Posted by T4Jumper

Wow, this is very intriguing. I would love to see a few more pictures of different angles. Have you tried flexing it out yet to see if it rubs the body mount then?

I love the idea of this tire size because I'm a huge fan of running stock wheels and being able to clear the UCA without spacers is awesome.

I can do that. So far I’ve only used a jack to try and flex it. I’ll get some more pics showing the UCA and body mount clearance as well as some others.

I’ll update this down the road with more

2021nightshade4x4 · 11-16-2022, 10:47 AM

Quote:

Originally Posted by JLtoTRD

BFGs are notorious for running small so even though they say 34" I guarantee they are a "large" 33".

According to Discount Tire and many other sources, BFG’s in flotation sizes measure at 0.5” smaller diameter than stamped. Width runs true.

Metric sizes are as marked.

Sent from my iPhone using Tapatalk

honda250xtitan · 01-17-2023, 11:02 PM

Quote:

Originally Posted by 4Brewz

I can do that. So far I’ve only used a jack to try and flex it. I’ll get some more pics showing the UCA and body mount clearance as well as some others.

I’ll update this down the road with more

how have they been?

4Brewz · 01-20-2023, 12:09 AM

Quote:

Originally Posted by honda250xtitan

how have they been?

Great, no complaints. Seem to be inline with other reviews on the AT3s in the more popular sizes.

I haven't had a chance to take it anywhere significant and flex it out, just some mild stuff but no rubbing so far.

The only rub I have experienced is backing into a parking spot with the wheels turned almost all the way. I get the most minor rub in the BM location. Not enough to warrant a BMC, but I may at some point just to future proof things.

I do like them though. That said, Ill likely keep long term. Next set will be these or 35x10.50s with more lift.

Site Navigation