FS: 4.30 E-Locker, Axle housing, Matching front Clamshell - Las Vegas $500
Hey,
I have two rear 4.30 E locker thirds and abs Housings and one matching front 4.30 Clamshell. I have not run the thirds but the gears look good and the motors bench tested good. They are complete and the wiring is cut right at the factory harness before the plug. Ready for you own harness or plug into an existing harness.
I am asking $500 for a e-locker third $200 for the front diff and $100 for a rear housing.
I'm in North Las Vegas and willing to drive a little bit if it helps.
92 with brand new motor to to bottom and an 02 cr250r chassis with an 89 cr500 engine. The 02 throws around like a mt bike, but the 92 has a ported cylinder and well... its fun too.
I honestly couldn't tell you the mileage. When I see gear problems in toyota's its normally been due to big tires and big beer drinking
I did pull them from the local wrecking yard so I can tell you they didn't come off an abused trail rig.
I honestly couldn't tell you the mileage. When I see gear problems in toyota's its normally been due to big tires and big beer drinking
I did pull them from the local wrecking yard so I can tell you they didn't come off an abused trail rig.
ok well that sounds good. i recently found a chunk of diff on my front drain magnet and now this pops up again. i may have to meet you somewhere when i get paid next week.