Recent content by '15WeissRhino

Still for sale... Bump

Bump, still for sale.

Engine and trans factory skid plates from 2015 Trail Premium w/KDSS. Some scrapes and scratches, but no major bends.

I'd like to sell it all together.

Removed after 1 year of use, excellent condition. Comes with all hardware, $100. Silver rails are covered with black PlastiDip. Prefer not to ship.

Yes, mine are on the second groove(0.5 inch average lift). I'm down from the 1.75" to about 1.5 inches above factory in the front now. Installed the 5160's on the rear a couple weeks ago and then had it aligned a second time last week. Gained about 1/8" in the rear with the new shocks. My...

Sold my OEM fronts several days ago and unfortunately didn't get a measurement. Had a thought about this last night. If the 6112's are very similar to the ones on the TRD Pro, isn't the TRD Pro about 1 inch higher in the front than a standard 4Runner? If that's the case, the .5" Bilstein setting...

Exactly what Saker said, the guys(Mike and his team) at Bilstein are going to try and get some data for us. I took mine in for the alignment yesterday. The right side lost 1/8" of height and the left side gained 1/8" height. This was with the lower shock mount bolt torqued with the 4runner on...

Haven't talked to anyone from Bilstein or TAP, will give them a call when I get home later this week. The spring seats are in correctly and evenly seated over the split ring according to the instructions, springs are in so the lettering is right side up and the upper spring seat/hat is aligned...

Like new(1,300 miles) condition OEM Tokico struts off 2015 TEP. Just need the top hats to install. Not willing to ship.

Yeah, mine looked really low in the front from the factory, so I thought the half inch or so would be a nice change. Going to have to live with the 1.75 inch change, because I'm not going to tear it all apart again:) Might just add a spacer to the rear eventually, but it's close enough to level...

My original front measurements were: LF= 34 3/8", RF= 34 3/8", rears have remained the same. Might have settled a bit from my original measurement. Definitely a lot more than the .5 of an inch average the instructions stated.

Here's what I got for measurements in the garage, from the ground to the top of wheel well: LF= 36 1/8" RF= 36 1/8" LR= 36 7/8" RR= 36 3/4" Hope this helps.

I used the second lowest setting, the second groove up from the bottom. It's the groove that the Bilstein instructions call their "0.5" AVERAGE LIFT". The grooves are about 10mm apart. Did the install myself, but used a local 4x4 shop to compress/remove the factory spring hats and reinstall on...

Sounds like I was one of the lucky ones to receive the 6112's about a week ago. Just finished the install on an otherwise stock 2015 KDSS suspension. Thought I better share my results. Using the 0.5" average lift circlip grove setting, I measured a change of +1.75 inches in ride height. Drove...