Recent content by 4.0sr5

I’ve had my 03 v6 4wd for quite some time now so I’ll add my experience for anyone curious. 230,000+ mi, still on the factory alternator, PS pump (been weeping for the past 3 years) PS rack, C.V. axles, wheel bearings, master cylinder, ball joints tie rods. Truck has been absolutely dead nuts...

I can offer you $200+ shipping. Any more and I'd be better off buying new. Shipping costs estimated at $80-95

Hi Guys, These came off my 2003 Toyota 4Runner. They are the Toyota factory 6 lug, 16" wheels with used MasterCraft Courser AXT 265/70R16. I did not clean them prior to removal. They all held air and balanced well (with a good tire tech) before I removed them. Some have lost air while stored and...

Anything?

I'm very interested. $250 +shipping to 02780 Commercial Address.

$150 for the Gibson shipped though... I'd cover the ship of course. Am I asking for too much?

Just tying the knot on this thread for anyone looking for a DIY on the 1GR-FE water pump. Found this on a Taco site. https://www.tacomaworld.com/threads/diy-2nd-gen-water-pump-replacement.206244/

I'm I too late to reply? Most likely. Do you have to drop the pan? No. Main benefit of dropping the pan is inspecting the condition of the pan magnets, and replacing or cleaning the filter screen. Is dropping the pan more work? Absolutely. If I was torn between dropping the pan, etc. or...

$350 for 4 wheels? I'll pick up personally, I'll bring cash or PayPal. Soonest I can get there would be this Friday the 14th.

Looking to buy OEM 17" split spoke wheels found on the Tundra and Sequoia. Will pay for shipping obviously... thanks in advance.

I am experiencing the same rumble type noise front drivers side. Sounds to me like a wheel bearing, however I've had two mechanics check (I don't have much faith in most mechanics) both stated the wheel bearings were not the issue, and its probably my tires. I have probably about 5-10k miles on...