Recent content by 4flyer

Did a radiator flush yesterday.

Looking for a bezel for my 01. Must have no cracks. Thanks!

Looking for a wood grain radio bezel for the 99-02. Must have no cracks in it. Thanks!

I will take the bezel if it is still available

Sounds good. My engine is completely torn down at the moment. No timing belt. And I don't have that tool. I think given the situation, it might be best to: 1. Remove both camshafts as the TB is not installed 2. Measure the shim thickness as I already know clearance 3. Calculate the new shim...

Putting my engine back together after getting a cracked head. I was checking clearances and many of the valve clearances are out of spec and on one of them, there seems to be no clearance whatsoever. Probably my fault. With the new head that came from Clearwater, my buddy held it upside down...

Does anybody know if an ARB front bumper for a 2005 4Runner will fit on a 2001?

Could be that the engine is just tired. 155 PSI is pretty low

Hey guys! Awhile back, I was troubleshooting an issue with my engine, Lo and behold, I have a crack in my head at the #3 cylinder, surprise surprise. In the process of looking at heads to replace it. Seems like there are several great options but I don't know what road to go down, especially...

This is a follow-up to this thread: https://www.toyota-4runner.org/3rd-gen-t4rs/315743-do-i-have-blown-head-gasket-based-off-these-compression-readings.html#post3853378 Hi guys, For this slow running project, I finally got word from the machine shop what they found. They said, to my...

Hey! I am ordering parts for this huge job. Head gaskets (likely replacing a cracked head), water pump, timing belt, etc. Can somebody make sure that I have all the parts I need? I think I got it down. Been following the parts that mtbtim had listed on his series. Any parts added that I do...

You mean option #3 with new Yota 1 heads? Same engine

If doing new heads, is it okay to replace the cracked head only or is it best to do both sides?

Right on. How long did the job take you? I need to make a list of what else to do. I have a bunch of cracked rubber!

Thanks, Tim. I have watched your videos and they are an absolute treasure. I will going into this as a head replacement as well :)