Recent content by 5lugger95

FYI to those thinking of doing a lower uniball conversion in a similar fashion. I'm about to make the LBJ pucks to hold the 3/4 bolt. it seems like there is only around 11mm of depth the puck can have so that the bolt head can sit flush below the LBJ bracket and does not interfere with the CV...

Was there any modification needed to run the 3/4 helms on the upper arm? Im assuming the stock long UCA bolt is not a 5/8s that will fit into the misalignments?

Very cool, that all makes sense. I see camburg sells the upper uniball adapter for $50, so thats a no brainer to me. Also I opened the files and see that there is only one side modeled, is it just a simple case of cutting out X2 of the plate and flipping it over for the opposing side? Files...

Thanks a lot for posting this up man! I have a couple questions: 1. The uniball slug pressed into the LBJ, did you machine it to taper off at the end like the LBJ housing does? Or is it just a 1.5" diameter slug? 2. Is the kit pretty much stock geo, extended 3.5, with the upper and lower pivot...