Recent content by 73Duster440

42" Curved Auxbeam on Relentless Fab Mounts (Low profile and tucks bar very close to top of windshield) Rigid Dually D2 Driving Lights on CBI Ditch Mounts Rigid 10" SR-2 Spot in Hood Scoop Rigid SAE Approved Fog Lights in the bumper Not shown are A Series rock lights in Green & Red as well. I...

what rear is this? saw in your previous posts it had disc brakes is that a landcruisier axle?

Man those are Sick! Cant wait to see them installed been eyeing those and white F5s in the same size for awhile now but can't decide

I have noticed it runs a bit cooler Currently fluctuates between 183-187 in 90+ ambient temps (Florida) with A/C on Previously with the old rad it was a consistent 190 all day long Brake fluid just looks dirty in the pics. The master cylinder and fluid are only a few months old. Did a full...

Last Sunday I finally dropped my CC1998 Champion Radiator in with new upper and lower radiator hoses and trans soft lines. It was close to a drop in. Was a bit mangled in shipping but I was able to make it all straight again. I had to open up the radiator holes in the core support one size to...

Thank you sir. I owe ya one. Just completed this earlier today how you have it and no CEL Ended up mounting it on the firewall just above the booster to keep it out of the way and to keep it tidy. Almost look like its factory. Now I have room to mount my fuse box and have all the relays hidden...

I picked up the Rigid 50481 Dually DOT approved fogs and mounted them in my stock bumper for $154. The width and definition of the beam pattern is crazy. Yes, they area little pricey but for the quality and the fact they are actually DOT approved and LEGAL to run on the road it is worth it...

It is awesome to have my baby back after parking it over a week ago after losing brakes. Pull past my driveway as I always do to back in. I stop then start to back up and as I hit the pedal to slow down to hit the miami curb at the end of the driveway she just keeps rolling. :frusty: I got an...

I went with the Hella Supertones for $30 on Amazon They are stupid loud and look bad@$$ through the grille

No, didn't have to tub the rear but have trimmed/ rolled the wheel lips. The wheels are flush to the 1/4s right now so I have tons of space to the inner wheel well. I want to get my rear suspension all setup to see if I can clear them w/o hitting the 1/4s. Worst case I'll need to pull the wheels...

Thanks Cajun I used some old garage door L brackets that I had laying around. They look just like these...

Thanks man! Honestly I could do w/o the roof bar anymore after adding the others but I have it so F it. Plus I wouldn't be able to have just over 43,000 raw lumens :banana: That's awesome old Mopars are so much fun. I'm building it for autocross/ road racing and beating the living $hit out of...

Dont be that guy that drives with a light bar on on the street. Every person I see driving with one on I just want to beat them senseless. :gun6: With those people it usually starts with my flashing my brights on in the hopes that they turn it off. But when they leave it on then I flash my D2...

Finally upgraded to the cs-144 alternator and did the big 3 mod also. Was much easier to make battery cables than I thought. I used the Chevy to Toyota adapter harness that can be found online and instead of stacking up a ton of washers to locate the alternator in the bracket I used a small...

Thanks :thumb: Wasn't even sure what to call it to try and look for it Thank you!