Recent content by 773_T4R

https://www.amazon.com/gp/product/B06WW51NB2/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1 I cut off the 12v plug and ran these to a power distribution block that I have in the back but it can easily be routed to the cig lighter

Nope, 2007 SR5 with 5th gen TRD Off Road wheels. It sees a decent amount of dirt and mud. I have had the CV's replaced a while back and now the bearings. Only thing I can think of now is something with my brakes which I will be replacing soon as well. 138k miles

Replaced Wheel Bearings Replaced both side wheel bearing assemblies. Driver was on it's way out and passenger was past due. No more bearing noise! These were a PITA to get off...broke 3 flat heads and a chisel but they eventually came off. Now to diagnose this squeak when I turn left....

I probably will...driving on the highway yesterday, I was watching it and there's a bit more movement than I'm comfortable with. I just wish the Fourtreks were able to mount on the factory rail. I wanted to keep it as low as possible and not mounting it to the Rola

Arb 2500 Got my ARB 2500 and awning room delivered and installed using some L-brackets from the hardware store

Once you pop off the plastic covers on the corners and remove the rubber pieces in the channels, you should be able to loosen the knobs on the crossbars and slide them right out. https://www.youtube.com/watch?v=DlY6Y6p-9rQ This is an installation video but it gives a good idea of how they go...

What bulbs did you go with? Thinkin about converting front and rear turns to LED's too

I had just the shell but everything from the 07 directly swapped to the 03-05 shell with no problem. My guess is that the Limited trim would have the most "stuff" in terms of electronics and extras. I have an SR5 but used a shell from a Limited.

They are a direct swap. The one I swapped to my 07 was from an 03-05.

It's not too bad, just keep a track of all your nuts and bolts. -Definitely need two people to take the tailgate off. -When removing the glass, remove the rubber weather strips first and then pull the glass out (requires rotating the glass). -When plugging back in the computer module for the...

Cargo area lit up with just an LED bulb replacement: Cargo area lit up with LED bulb and 4x LED strips off Amazon: (I can see in my drawers at night now!)

Started swapping everything over from the rusty tail gate to the non-rusty shell that I got from another 4runner. There is a lot of crap to swap over haha

I used those clamps on my Rola rack for my rear LED pods and they work really well

Living in Chicago, yes. I usually have a step that I put in the hitch receiver but I haven't had time to switch it out from the last trip to the off road park.

Installed my sliders from PP Engineering based out of Indiana. These are some beefy sliders!