Recent content by 83Mule

https://www.toyota-4runner.org/attachment.php?attachmentid=372475&stc=1&d=1606094256

I expected a Gerbil to be running in the ''Hoop'' of those Blingmaster Rims......

https://www.toyota-4runner.org/attachment.php?attachmentid=372357&stc=1&d=1605918421 This is my first Toy, and I thought the chrome Jackmans, puny rollbar and square lights were ''Cool'' Looking at it now it's horrible, but options were limited and I was 18! I had been a Chevy and Datsun Man...

Optional Supercharger Boost Port..........

As far as ''Cool''.........I only care if it looks cool to ME! I have a sense of what I think looks cool and it's probably mine alone. If someone else likes it then that's cool too. I am old enough to not care for the ''Everything flat black'' look.......I like old school Shiny Chrome and...

The outer edge will look feathered from scrubbing when you turn, but the center never loses contact so it is smooth. Chalk it and drop pressure to get a full contact patch .....

Too much pressure.....crowned in the center. Try 36 all around for a week and see if you use all the tread in daily driving.

https://www.toyota-4runner.org/attachment.php?attachmentid=372013&stc=1&d=1605227043

I have 17x9, 4.5 and -12 and fits fine. The 4'' backspace is the question.

I think you are saying the blower motor for the HVAC is on? It must be shorting from water so it is getting power. You are going to have to dry out the switch/control board to stop it or replace same IMO.

I marked mine with install paint and can see if they move.....50K and no issue. They work by the clamping action on the mating surface with proper torque. The cause of an issue will be the lack of torque allowing the rotation of the spacer which will shear the lugs. Simple......torque it and if...

My 275 BFG A/T with a lift cost me 1 to 1.5 over stock and my 285 C's have made no change to that. You don't need to regear until 34'' and up IMO. With a Pedal Commander I get better MPG and enjoy the response over flooring it and getting Marshmellow on my Boot like stock does!

Some folks need to quit obsessing over Moly content.......some oils go another route on wear additives and a lower Moly count is not a sign of a less effective oil. Most of Projectfarm's ''tests'' are irrelevant to practical use tests.

Mine are from Plasticman and they are way better than stock.

If you only did ONE window it should BE the windshield.....most angled into the sun and the greatest surface area so the most Bang for the Buck! I did my whole 4Runner with clear on the front and tint down the sides and back in Ceramic for $400......worth it here in HELL!