Recent content by ACK350

06 Galactic Grey 4runner in NC Sent you a PM

Correct, mine are at 1.75. I actually want to go to the highest setting. Curious if it can be done with factory UCA...

Thanks! And no new UCA needed for this set up. I'm running my factory set up with no issues.

SOLD!! please close

4 limited rims w/nitto terra grapplers in NC .. $550 http://www.toyota-4runner.org/sale-suspension-wheels-tires/195008-fs-4-4g-18-limited-wheels-tires-nc-%24550.html

I have my 06 Limited 18" wheels with 265/70 terra grapplers tires for sale. Tires have about 50% tread remaining with less than 10k of mileage. I bought new wheels/tires and have these stored in my garage. No TMPS, located in fayetteville,NC. Prefer local pick up for now will consider shipping...

Pm sent

I think I was the only one who mentioned using silicon to seal my lights. I only did it as a precaution due to my last set leaking. Everyone else seems to have good luck with the lights. I don't remember the brand I used but I just bought some waterproof air tight sealant from advanced auto

The 06 and up with the projectors actually put out a nice even light patten. I have 5k HIDs and they bring the daylight lol. On mine they have an adjustment knob, not sure if yours have this or not. If so it could possibly help

I must've been the one to get the bad ones lol. Mine starting getting a lot of moisture after 1 month of buying them. I contacted the seller who stated that they are only covered for 15 days after the purchase for defects lol. After a lot of back and forth we came to an agreement that I would...

I have 4 18 inch limited wheels with 265/70 series terra grappler tires for sale. I just took them off today for a set of aftermarket wheels/tires. I'm in NC. Can get more pics of the set but only took 1 at the moment. Tires are 70% thread life.

billstein 5100's Fj Springs Daystar 1.5 rear spacer 1/2 inch body lift 1.25 Spidertrax 17 x 8.5 -6 MB TKO Wheels 285/70/17 BFG AT2

I have a all led set up on mine and they are plenty bright without the high cost of tritons.. I got a set from ijdmtoy that has the resistors built in so you don't have to splice anything

Thanks for all the help from people on this thread. I'm very happy with my current set up. 5100s set 1.75 with fj coils all around and 1.5 d/s spacer on the rear. Ride is firmer with the billsteins but to me it's perfect.

I would like a similar stance as Blackoutts t4r a few post up... Will I achieve that stance with removing the font DS spacer and just setting the 5100s at 1.75?