Recent content by adam2562

I ordered the KTJO4x4 harness to make my outlets 400w all the time and it was shipped no problem. And, the install went smooth.

For what it's worth i'm using a 350w Rockpals (similar to Jackery). i'm powering the Rockpals using the Cigg outlet in the rear which doesn't use the inverter. and then i'm using the Cigg outlet port on the Rockpals to plug the fridge in. and the fridge stays powered and the Rockpals battery can...

I can't tell what i'd need from that site to just use my original outlets at 400w. I emailed them. I'm thinking i just need the 2 wiring harnesses and no outlets.. but do i need a longer cable for the rear outlet?

How has that Alpicool been? i'm consider a C30 or C40

There was a TSB for this where they replaced my rear driveshaft on my 2010 limited and on my 2011 trail. https://www.toyota-4runner.org/attachments/4th-gen-t4rs/71427d1347733801-t-sb-0121-12-its-finally-here-t-sb-0121-12-pdf

Just here to say that the 12Volt Solutions has worked fine for 2 years now in my Avalon.. I've got a Viper in the 4runner.

Was there ever a write-up for these speakers with the JBL system?

was there ever a substitute mirror found for the early 5th gens?

let me know what they do for you in this instance.. i had duratracs that way.. all 4 were very out of round.. i dealt with it.. they were great tires otherwise.. mainly because i didn't want to deal with pulling them off and the next set being the same way.

Is there a write up for it? Im waiting till LED's arrive

thanks man.. but that post must have been from 2+ yrs ago. i've already got SPC arms and i like them but i need the updated ball joints and they never responded to my email

you know.. what if the system is over compensating because it knows it's at a different angle(height, when you lift) so therefore it's pressurizing it at a higher amount and that pushing on the cylinders on that side causing it to over extend? i'm just throwing this crazy thought out there for...

i have an adjustable trac bar and that didn't fix it :( just helping your theories by ruling that out

i've personally been this deep as i submerged into a water hole in the outer banks. once the hood went under water i floored it to pull out if at all possible. came out and no water in my airbox believe it or not

I'll check my skids but i was just under there recently.. i really need to just have someone listen for the location of the noise as i pull out.. just thought id hear different opinions.. its a different clank than when i had it nefore and fixed it by replacing sway bar bushings. And it wouldn't...