Recent content by alaskaflyer

Message sent about oil cooler. Sent from my SM-G988U using Tapatalk

PM'd

Thanks for the input. I know there is a 50/50 chance I got Junk. Hoping for the best.

Including what parts on the JDM motor will, or will not work? I have found a lot of good info on the swap itself, just some conflicting info when it comes to the JDM motor.

Do you have any videos or advice on doing the swap from a 3.0 to 3.4 with a JDM engine?

Great write up! I'm swapping a JDM into a 95 with a blown 3.0l. I don't have another 3.4 to compare side by side, but I'm sure I'll figure it out, I'll just go over your write up with a fine tooth comb. Thanks for putting in the effort!

Hey just checking to see if this is still available? Thanks

I'm in the Fairbanks area. Just got a '95 that I'm going to rebuild. Once I get it up and running would be interested in meeting for doing mods or other maintenance related type things!

Part of the '95 club I just recently acquired a 95 for 800 bucks. Needs new motor so I may just go with a 3.4 swap. I can get one from JDM for around 2k. Love your build, but being up in Fairbanks with no garage and work being so busy in the summer this could take awhile!!! Great write up.

I have a 1999 limited. PM me if interested.

I installed a drop bracket for the bar. Attaches to the frame and drops the bar. So far so good and a cheaper alternative to the custom quick disconnects.

I bought a heater servo for my 99 limited from Nissanh, price was fair and shipping was timely. I would buy from again. Item works perfectly and saved me close to 100 for the part, and a few hundred if I would have had the dealer install the part. a few bucks and 20 minutes and I was good to...

Picked up a Servo from forum member, everything is working as it should again. Only took about 20 minutes. :bluejump:

Part number?

I think I'm having this problem now. I get the clicking from the servo, and all I get is heat, AC no longer works. Does this sound like the same issues you guys have had.