I tried to search and was not able to find anything. My wiper do not work on the first setting (INT). They work on all of the other settings just fine . When I turn them off they will just STOP, they will not return to the rested position. I was wondering if anyone else had this issue and if...
Yes, I have the C load range.
I know some people inflate up to 40 PSI or so. I am looking for "maximum contact" so that I get even tread wear on the entire tire. Without a "chalk test" even at 30 PSI they seem "over inflated"
I found the following while I was searching:
Weight of Truck
--------------------------- x Max tire PSI as indicated on sidewall
Tire max load rating (lbs)
multiplied by 4
A 4th Gen 4Runner (2004) is listed at 5710lbs on the door sticker.
I have the the LT265/70R-17, Duratrac Tire by...
I have a T1809 with the SC12235 Ipod interface cable.
I have a JBL - 10 speaker system that I was going to try to get this to work but decided that I am just going to save for up an after-market unit.
$175.00 shipped for the Radio and interface cable.
If you have a newer Ipod device I also...
It just came to me... If I have both 5100s set to the 3rd groove (1.75") and I am about 3/4" higher on the pass side, I could set that corner to the 2nd groove (0.85") which should make the driver side about ~1/4" higher ??
Would that be doable without any neg affects ?? Would the shocks be...
Since the pass side is about 3/4" higher then the driver. Would I be able to use one 1/4" Front Top Plate Spacer which adds approximately 1/2" lift from Toytec ?? They have listed on the page "Great for correction of drivers side ride height." Any long term harm in running a 1/4" spacer only on...