Recent content by aussiebobaustin

Thanks Charlie, what if my 2002 is a 2WD 5 speed manual ... will the 03/04 Tacoma ECU work ? ( and matching wire harness ). The only way for me to do the research is to study the 2002 wire harness and compare it to the Tacoma wire harness ... which I plan to do if I can get the wire harness...

I have my 2002 swapped and added the Temp sensor resistor and added the Solenoids out of the old transmission . No CEL but no System readiness because there is no output shaft sensor.. Auto had 2 wire sensor, manual has 3 wire sensor. What to do ? Also where can I get the factory wiring...

I have done the swap on my 2002 Gen3 4Runner and used the above diagram ... I don't have any CEL light after driving for while but don't get any system Readiness. I suspect it may be since I don't have the output shaft speed sensor connected. BTW this is a 2WD not a 4WD . The 5 speed I...

I have a 2002 AT 4Runner where I swapped out the AT for a 5 speed MT. I have added a clutch depressed switch that is indicating "Parked" to the ECU. Now the motor will only start if the clutch is depressed. I added the resistor to the AT temperature sessor. I removed the solenoids from the...

For some reason I can't find the "diagram" ... I converted my 2002 4Runner to Manual and now need to do the wiring to not get the CEL. Can someone tell me where to find the subject wiring diagram.

Just got my Gen3 swap 3.4 auto to R150 I am curious as my spedo still seems to register even though nothing is connected to the new manual 5 speed . Also any ideas on swapping in a manual ECU and wire harness ... would I need to have the VIN and odometer reading updated to natch the old...

Did I miss the answer on if there is any difference between the two plugged ports ? I added an electric sensor to the easiest port to access from below. ( left in my image). I get the following readings ... 1. Cold at idle about 80 psi reducing to 28 psi when hot. 2. When hot , and under...

Hi Micah and others, I have a 2002 and the EVAP system is bad and I have to fix it to get it registered. I pulled the charcoal canister and couldn't see any cracks ... one of the vacuum controlled valves ( the one to the filling pipe) was not working ... I removed it and flushed it out and it...