Recent content by Banjo

Thanks. This gives me hope. I just picked up a 98 with a 00 engine and transmission. The transmission works fine but the theres no front driveshaft so I dont how the 4x4 does yet. The 98 is sr5 and the 00 transmission is limited... so I dont what issues I may run into with that as well. I'm...

That's how I intended to use them (Horizontal ). Once separated I don't think I'd have any reason to be under the body. Ill roll the frame out to work on everything then roll it back under when im done and reattach it.

Ha! I've held up a 4runner with alot less but if my project falls on the right paycheck I might just make a trip to harbor freight.

Only the basic tools and a jack. Ill use 4x4s for jack stanstands. My objective is to clean up the frame, put in new rear main seal, timing belt kit, work on some wiring, new body mounts, and maybe some other things. Figured it would be easier to do all that with body and frame separated so im...

3rd gen body removal Could someone direct me to a step by step body from frame removal. Thanks

My hose was attached to the actuator but couldn't find where it went to. Finally found it after taking shifters out from the inside of the truck and there's a port on top of the transfer case. I plugged it up and still no 4x4. I read a thread recently about swapping a multi- mode with a j-shift...

I just purchased a 2000 limited and there's a hose from the actuator on the transfer case just hanging. My 4x4 does not work. Where does this hose go and would it affect the 4x4?