Recent content by Beagle(4)Runner

Rear bumper Still have the bumper?

Thanks for the help

I have done google searches without any luck. Attached to the rear diff is a block that has the two hard lines to each wheel along with the rubber section the goes back to the master cylinder. Does anyone know what that part number is, mine is rusted and leaking somewhere? I have looked a...

Pm sent

Changed both LBJ with Orem. Went much easier than ones i have done in the past, used a large pitman arm puller to separate the ball joint from the lower control arm. Worked a lot better than a big hammer and fork. Also ordered set of Bilstien 5100s for the rear.

Any one have any recent experience with these springs?

ICON springs Are these for a third gen.

Installed Curt rear hitch and did rear diff breather. Fixed a loose strap on gas tank skid plate.

skid plate DO you have a front skid plate that is in decent shape, shipped to 15784?

Bump $45 plus shipping. Almost brand new. Great for towing or taking out some sag on stock suspension.

Got these a few months ago before my lift to keep my rear end from sagging from the weight of my drawers. Made for towing and heavy duty hauling. They have about 2000 miles on them and are in perfect shape. No longer need them. $60 plus shipping.

I just replaced the suspension on my 97 and wanted to know if what i took off was original, Front drivers side coil is blue blue, passenger side is blue yellow and rears are both a single orange mark. I am going to try and sell them on here and want to be able to give an accurate description of...

From what I've been reading the superflexs sound about right for the weight I'm looking at. Now granted the bumper isn't right now and if I end up sagging too much at that time I can always look to switch things up. I appreciate the help and info, just trying to learn a bit quicker. I'm reading...

I've got a rear drawer that probably has close to 150-200lbs in it so I'm hoping that'll drop me down to probably 3.5" with plans of a rear bumper in the future. So what year tundra 5100s do I need for the rear if I end up going tundras? And which would be better suited for me then? The tundras...

Okay so for the front I'm looking then eibach coils with 99-06 tundra 5100s and a 4runner top plate, correct? And for the rear superflex with tundra 5100s??? And in the picture it's my old 4runner, just a cheap rc lift. The one I'm currently lifting now is a 97 5spd that's still on stock...