Recent content by BigSkyMT

Do you have a scanner available? It might of set a code by now, like no crank signal. Do you have spark? Hissing noise, key on only? or while cranking only?

The mass air flow sensor should be able to compensate for the larger intake? All it does is measure incoming air and alters fuel mixtures/ignition based on its readings. Did you disconnect/reconnect the battery after installing the intake? To allow it to relearn? I would think after several...

Also check your grounds on the main wiring harness. I can't remember offhand where the grounds were at, been like 8 months since I did my last 3.4L. I think there was one at the back of the intake, and then maybe one around the oil filter area. There isn't many, I do remember that. Double check...

Your vibration and "squeaking" issue is more than likely a bad or binding Ujoint. Not your axle, wheels or rotors. I've seen them come into the shop before squeaking, while barely moving. It also didn't have any noticable play in while installed. Crawl under your driveshaft, and grab it near the...